Training System Pressure Control India

• This compact teaching/training unit offers every opportunity to learn the fundamentals of process control through experimentation on a pressure control system.
• The experimentation set-up is mounted on a solid housing which accommodates all the electronics.
• The process tank is charged with compressed air by a diaphragm gas pump.
• The advantage of the dial-gauge manometer is that the pressure in the tank can be observed directly at any time.
• The pressure is measured using a pressure sensor.
• The sensor output signal is sent to the software controller.
• The output signal from the controller influences the speed of the diaphragm gas pump and hence the delivery flow rate.
• An air consumer is simulated by way of a restrictor valve.
• A solenoid valve through which air can escape can be activated by the software to investigate the influence of disturbance variables. 
• The powerful state-of-the-art software is an integral part of the training system, embodying the principle of hardware/software integration (HSI).
• It enables the experiments to be conducted and evaluated in a user-friendly manner.

Diaphragm gas pump

• Max. flow rate: 3L/min
• Max. positive pressure: 1bar
• Max. Negative pressure: 250mbar abs.

Pressure tank

• Capacity: 400mL
• Operating pressure: 1bar
• Max. pressure: 10bar
• Pressure control range: 0...1bar
• Solenoid valve: Kvs: 0,11m³/h
• Pressure transducer: 0...1bar
• Manometer: 0...1bar